CAN COMMUNICATION SYSTEM > Brake Actuator (Skid Control ECU) Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Brake Actuator (Skid Control ECU) Communication Stop Mode | Either condition is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE) |
![]() |
Disconnect the A6 master cylinder solenoid (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A6-11 (CANH) - A6-25 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Master Cylinder Solenoid [Skid Control ECU]) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Disconnect the A7 master cylinder solenoid (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A6-1 (GND1) - Body ground | Always | Below 1 Ω |
| A6-32 (GND2) - Body ground | Always | Below 1 Ω |
| A7-4 (GND3) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A6-2 (+BM1) - Body ground | Always | 11 to 14 V |
| A7-2 (+BM2) - Body ground | Always | 11 to 14 V |
| A6-31 (+BS) - Body ground | Always | 11 to 14 V |
| A7-1 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Master Cylinder Solenoid [Skid Control ECU]) |
|
| ||||
| OK | ||
| ||