Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › CERTIFICATION ECU

CERTIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL CERTIFICATION ECU
  1. Attach the 2 claws to install the certification ECU.



2. INSTALL ECU INTEGRATION BOX RH
  1. Install the certification ECU with bracket with the 2 nuts and bolt.

  1. Attach the clamp and connect the connectors.



3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
  1. Attach the 3 claws to install the air duct.

  1. Install the screw.



4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.

  1. Attach the 10 clips and guide to install the lower instrument panel sub-assembly.

  1. Install the 3 screws <B> and 2 bolts <C>.



5. INSTALL INSTRUMENT PANEL BOX DOOR COVER
  1. Attach the 2 claws and 2 guides to install the instrument panel box door cover.

    HINT:
    Use the same procedure for all the instrument panel box door covers.



6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240163
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 8 claws to install the instrument panel airbag.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



7. INSTALL LOWER INSTRUMENT COVER LH
  1. Attach the 4 claws to install the lower instrument cover LH.



8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.



9. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



10. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



12. REGISTER ECU CODE
  1. Register the ECU code (Click here).



13. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light .