Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Power Seat Position is not Memorized

for Preparation Click here


DESCRIPTION

When the seat memory SET switch and a memory switch (M1 or M2) are pressed simultaneously, the main body ECU commands the position control ECU through CAN communication to record the value of each position sensor.

WIRING DIAGRAM


B358390E01


INSPECTION PROCEDURE

NOTICE:
The front power seat control system (w/ Memory) uses the CAN communication system. First, confirm that there are no malfunctions in the communication system by checking the communication function of the CAN communication system (Click here).

1.CHECK FRONT POWER SEAT CONTROL FUNCTION
  1. Check that each function of the power seat operates normally by using the front power seat switches (Click here).

    OK:
    Each function of power seat operates normally by using seat switches.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


2.READ VALUE USING TECHSTREAM (SEAT POSITION MEMORY)
  1. Use the seat memory switch to record the seat position (Click here).

    NOTICE:
    1. The seat position will not be recorded if the SET switch and both memory switches are pressed simultaneously.
    2. If a memorizing operation has failed, release all switches. The seat memory function does not operate unless the switches are released.

  1. Using the Techstream, read the Data List (Click here).

    Driver Seat 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Seat Memory No1
    Seat position memorized with M1 switch / Mem or Not Mem
    Mem: Memorized
    Not Mem: Not memorized
    -
    Seat Memory No2
    Seat position memorized with M2 switch / Mem or Not Mem
    Mem: Memorized
    Not Mem: Not memorized
    -

    OK:
    "Mem" is displayed on the tester.



NG
Go to step 3
OK

END (USE SIMULATION METHOD TO CHECK) (Click here)  

3.INSPECT SEAT MEMORY SWITCH
  1. Remove the seat memory switch (Click here).

  1. Inspect the seat memory switch (Click here).



NG
REPLACE SEAT MEMORY SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - SEAT MEMORY SWITCH)
  1. Disconnect the F9 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the h3 seat memory switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F9-23 (M1) - h3-3 (M1)
    Always
    Below 1 Ω
    F9-6 (M2) - h3-4 (M2)
    Always
    Below 1 Ω
    F9-12 (MM) - h3-2 (MRY)
    Always
    Below 1 Ω
    F9-23 (M1) - Body ground
    Always
    10 kΩ or higher
    F9-6 (M2) - Body ground
    Always
    10 kΩ or higher
    F9-12 (MM) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE FRONT POWER SEAT SWITCH LH
  1. Replace the front power seat switch LH .

  1. Perform the memory operation (Click here).

    OK:
    Memory operation is normally.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
OK

END (FRONT POWER SEAT SWITCH LH WAS DEFECTIVE)