CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY LH (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Read the precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the roof headlining (Click here).
![]() |
Install SST.
Disconnect the connector.
Connect SST connector to the curtain shield airbag.
![]() |
Move SST at least 10 m (32.8 ft.) away from the vehicle front side window.
| *1 | Battery |
| *a | 10 m or more |
Maintaining enough clearance for SST wire harness in the front side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press SST activation switch to deploy the airbag.
| 3. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY LH (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Remove the curtain shield airbag (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag.
![]() |
Using a service-purpose wire harness for the vehicle, tie the curtain shield airbag to a tire.
| *a | Wire Harness Diameter |
| *b | Stripped Wire Harness Section |
![]() |
Position the curtain shield airbag inside a tire with the airbag deployment side facing inside.
| *a | Width |
| *b | Inner Diameter |
Tie the curtain shield airbag to the tire with several wire harnesses.
![]() |
Connect SST connector to the curtain shield airbag.
![]() |
Place tires.
| *1 | Tire (2 or more) |
Place at least 2 tires under the tire which the curtain shield airbag is tied to.
Place at least 2 tires over the tire which the curtain shield airbag is tied to. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
![]() |
Connect SST connector.
| *1 | Curtain Shield Airbag Assembly |
| *2 | Battery |
| *a | 10 m or more |
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire which the curtain shield airbag is tied to.
Press SST activation switch to deploy the airbag.
![]() |
Dispose of the curtain shield airbag.
Remove the curtain shield airbag from the tire.
Place the curtain shield airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.