Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    31    Short to GND in Hall Effect Sensor Power Circuit

for Preparation Click here


DESCRIPTION

When there is a short to GND in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly does not operate the automatic running board.

DTC No.
Detection Condition
Trouble Area
31
The side auto step motor hall sensor voltage is less than 4 V when the automatic running board is in operation.
  1. Wire harness or connector
  2. Side auto step motor assembly
  3. Side auto step controller ECU assembly

WIRING DIAGRAM


E237748E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR POWER SOURCE)
  1. Disconnect the O25*1 and N23*2 side auto step motor assembly connector.

    1. *1: for LH
    2. *2: for RH



    E237749E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    O25-3 (+1) - Body Ground
    When the automatic running board LH is being deployed or stowed.
    8 to 11 V
    for RH:
    Tester Connection
    Condition
    Specified Condition
    N23-3 (+2) - Body Ground
    When the automatic running board RH is being deployed or stowed.
    8 to 11 V

    Text in Illustration 
    *A
    for LH
    *B
    for RH
    *a
    Front view of wire harness connector
    (to Side Auto Step Motor Assembly)



NG
Go to step 2
OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the A41 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A41-14 (SSR+) - Body Ground
    Always
    10 kΩ or higher
    A41-14 (SSR+) - A41-5 (SSR-)
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY (Click here)