VEHICLE STABILITY CONTROL SYSTEM > A-TRAC Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 2.INSPECT TRACTION CONTROL SWITCH (A-TRAC SWITCH) |
Remove the A-TRAC switch (Click here).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (ATRC) - 5 (E) | Pushed in | Below 1 Ω |
| Not pushed in | 10 kΩ or higher |
| *a | Component without harness connected (A-TRAC Switch) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - A-TRAC SWITCH) |
Disconnect the A6 skid control ECU connector.
Disconnect the U3 A-TRAC switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A6-13 (ATRC) - U3-8 (ATRC) | Always | Below 1 Ω |
| A6-13 (ATRC) - Body ground | Always | 10 k Ω or higher |
| U3-5 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (A-TRAC INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
Check the condition of the A-TRAC switch by operating the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A-TRAC Indicator Light | A-TRAC indicator light/ ON or OFF | ON: Indicator light on ON: Indicator light off | - |
|
| ||||
| OK | ||
| ||