Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > A-TRAC Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The A-TRAC does not operate even if the A-TRAC switch is pressed under the following conditions:
  1. The TRAC or VSC system is faulty.
  2. The temperature inside the hydraulic brake booster increases and the A-TRAC operation is suspended.

WIRING DIAGRAM

Refer to A-TRAC Indicator Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.INSPECT TRACTION CONTROL SWITCH (A-TRAC SWITCH)
  1. Remove the A-TRAC switch (Click here).



    C215808E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (ATRC) - 5 (E)
    Pushed in
    Below 1 Ω
    Not pushed in
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (A-TRAC Switch)



NG
REPLACE TRACTION CONTROL SWITCH (A-TRAC SWITCH) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - A-TRAC SWITCH)
  1. Disconnect the A6 skid control ECU connector.

  1. Disconnect the U3 A-TRAC switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A6-13 (ATRC) - U3-8 (ATRC)
    Always
    Below 1 Ω
    A6-13 (ATRC) - Body ground
    Always
    10 k Ω or higher
    U3-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.READ VALUE USING TECHSTREAM (A-TRAC INDICATOR LIGHT)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.

  1. Check the condition of the A-TRAC switch by operating the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    A-TRAC Indicator Light
    A-TRAC indicator light/ ON or OFF
    ON: Indicator light on
    ON: Indicator light off
    -

    OK:
    The Techstream displays ON or OFF according to A-TRAC switch operation.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)