Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1268    Transfer L4 Position Switch Circuit

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1268
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN.
  1. Transfer system

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.INSPECT TRANSFER L4 SHIFT
  1. Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
    Result 
    Result
    Proceed to
    OK
    A
    NG (for Part-time 4WD)
    B
    NG (for Full-time 4WD)
    C



B
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)

C
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
A


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Shift the transfer to L4, drive the vehicle, and then check for DTCs.
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)