Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

DTC    C1883/83    Speed Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The stabilizer control ECU receives the speed signal from the skid control ECU via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1883/83
The stabilizer control ECU continuously receives a speed sensor malfunction signal from the skid control ECU for 1 second.
  1. Brake control system
  2. CAN communication system
  3. Stabilizer control ECU

INSPECTION PROCEDURE

HINT:
If DTC U0122/71 and C1883/83 are output at the same time, perform the inspection necessary for the CAN communication system first (Click here).

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for speed sensor malfunction DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE STABILIZER CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)