Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

DTC    C1884/84    Steering Angle Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The stabilizer control ECU receives steering angle information from the steering angle sensor via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1884/84
Either condition is met:
  1. The stabilizer control ECU receives an error signal from the steering sensor for 5 seconds.
  2. A steering sensor BAT terminal open circuit malfunction signal is continuously received for 5 seconds.
  1. Steering angle sensor (Spiral cable sub-assembly)
  2. CAN communication system
  3. Stabilizer control ECU

INSPECTION PROCEDURE

HINT:
If DTC U0126/71 and C1884/84 are output at the same time, perform the inspection necessary for the CAN communication system first (Click here).

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for steering angle sensor malfunction DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE STABILIZER CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)