Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the Safety Connect system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK
      1. When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:
        What
        Vehicle model, system name
        When
        Date, time, frequency of occurrence
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      5.VERIFY THAT CUSTOMER SUBSCRIPTION IS ACTIVE
      1. Enter the VIN into Vehicle Inquiry on the Techstream and verify the subscription type and expiration date.


      NEXT


      6.PERFORM HEALTH CHECK
      1. Perform "Health Check" and check for current DTCs (Click here).
        Result 
        Result
        Proceed to
        No DTC is output
        A
        DTC is output
        B
        PRL update required
        C



      B.
      GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)

      C.
      PERFORM PRL UPDATE (Click here)
      A


      7.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B

        HINT:
        If the symptom does not recur and no DTC is output, perform the symptoms reproduction method (Click here).



      B.
      Go to step 9
      A


      8.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Refer to Terminals of ECU (Click here).

      2. Refer to Data List / Active Test (Click here).


      NEXT


      9.ADJUST, REPAIR OR REPLACE

        NEXT


        10.CONFIRMATION TEST

          NEXT

          END