Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > UNABLE TO CONNECT TO CALL CENTER

for Preparation Click here


DESCRIPTION

This may occur when the intensity of the telephone radio frequency was very weak, PRL updates are required or the Safety Connect system has a malfunction, and a DTC is stored.

INSPECTION PROCEDURE

1.CHECK COMMUNICATION SERVICE CONDITION
  1. Move the vehicle.

    1. If the vehicle is outside the communication service area, move the vehicle to a communication service area, wait for a while and perform the operation again.

      OK:
      Same problem does not occur.



NG
Go to step 2
OK

END 

2.CHECK FOR DTC
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and wait for 10 seconds.

  1. Perform "Health Check" and check for current DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


3.CHECK PRL UPDATE
  1. Check for PRL update (Click here).

  1. Check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
Go to step 4
OK

END 

4.CHECK DCM OPERATION HISTORY
  1. Check "DCM Operation History" (Click here).
    Result 
    Result
    Proceed to
    Signal strength is weak (0 or 1)
    A
    Communication indicates "Fail"
    No problems with signal strength or communication
    B

    HINT:
    If there was a communication problem in the past but the communications are working correctly now, the source of the problem may have been temporary radio interference, or the vehicle may have been outside the service area.



B
END
A


5.REPLACE DCM (TELEMATICS TRANSCEIVER)
  1. Replace the DCM (Telematics Transceiver) (Click here).

    NOTICE:
    1. The ignition switch must be off.
    2. Do not replace the DCM (Telematics Transceiver) with one from another vehicle.


NEXT

PERFORM DCM ACTIVATION (Click here)