Home › Engine / Hybrid System › FA20 COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A278294
  1. Disengage the 7 clips and remove the 12 bolts and No. 1 engine under cover.



2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the local regulations.



    A277916
  1. Remove the service hole cover from the front bumper under cover.

  1. Connect a hose with an inside diameter of 8 mm (0.315 in.) to the drain plug.



    A277917
  1. Loosen the radiator drain cock plug.



    A279728
  1. Open the air bleed plug on the heater hose side. (for LHD)



    A279727
  1. Open the air bleed plug on the heater hose side. (for RHD)

  1. Remove the radiator cap and drain the coolant.



3. REMOVE FAN AND GENERATOR V BELT
(Click here)


4. REMOVE EXHAUST MANIFOLD
(Click here)


5. REMOVE WATER PUMP PULLEY


    A279725E01
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)



    A281162
  1. Remove the 3 bolts and water pump pulley.



6. REMOVE ENGINE WATER PUMP ASSEMBLY


    A279726
  1. Remove the 5 bolts, engine water pump assembly and water pump gasket.