Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    C110965E02
  1. Install the check ball body and the compression spring.
    Text in Illustration 
    *1
    Check Ball Body and Compression Spring
    *2
    Accumulator Piston

  1. Check the accumulator pistons, check ball body and the compression spring shown in the illustration.

  1. Connect the manual valve connecting rod sub-assembly to the manual valve lever sub-assembly.



    C109368E06
  1. Install the transmission valve body assembly with the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    Bolt Length 
    Bolt
    Bolt Length
    A
    25 mm (0.984 in.)
    B
    36 mm (1.42 in.)
    C
    45 mm (1.77 in.)
    D
    50 mm (1.97 in.)

  1. Install the detent spring and the detent spring cover with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. CONNECT TRANSMISSION WIRE
  1. Connect the 9 solenoid valve connectors.

  1. Coat the ATF temperature sensor O-ring with ATF.

  1. Install the ATF temperature sensor and the temperature sensor clamp with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the wire harness clamp.

  1. Install the valve body wire harness clamp with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
  1. Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

  1. Install the valve body oil strainer assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL TRANSMISSION OIL CLEANER MAGNET


    C109359E04
  1. Install the 3 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Transmission Oil Cleaner Magnet



5. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


6. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



8. ADD AUTOMATIC TRANSMISSION FLUID LEVEL
(Click here)


9. INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL


10. RESET CHECK RESET MEMORY
(Click here)


11. INSPECT EXHAUST GAS LEAK
  1. If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.