Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > ADJUSTMENT

for Preparation Click here



1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


2. ADJUST SHIFT LEVER POSITION
  1. While pushing the shift lock release button, move the shift lever to N.



    C257566
  1. Using tape, hold a 0.3 mm feeler gauge on the floor shift control select lever.



    C257565
  1. Using tape, attach the floor shift control select lever to the console box assembly.

    NOTICE:
    Make sure that the feeler gauge is not on the area shown in the illustration.



    C260577
  1. Remove the nut and disconnect the floor shift gear shifting rod sub-assembly.



    C116831E01
  1. Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.



    C260577
  1. Temporarily install the floor shift gear shifting rod sub-assembly with the nut.

  1. Tighten the nut while lightly pushing the lever rearward.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Do not push the lever too hard.



3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


4. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to M.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lock control unit assembly installation condition.



5. INSPECT FOR EXHAUST GAS LEAK