Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the lighting system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the ignition switch off.

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT


      4.INSPECT CAN COMMUNICATION SYSTEM*
      1. Use the GTS to check if the CAN communication system is functioning normally.

        Result:
        Result
        Proceed to
        CAN communication system DTC is not output.
        A
        CAN communication system DTC is output.
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM
      A


      5.PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table.
        A
        Fault is listed in Problem Symptoms Table.
        B



      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)

      2. Terminals of ECU (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END