Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    B1016    Shift Lock Circuit

for Preparation Click here


DESCRIPTION

When an IGN signal, P switch signal, and STP signal are input into the main body ECU (network gateway ECU), a signal is output to the shift lock control unit assembly.

DTC No.
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
B1016
  1. Ignition switch is turned to ON
  2. Shift lock circuit open, short to B+, or short to ground
  3. For 3 seconds or more
  4. 1-trip detection logic
  1. Shift lock control unit assembly
  2. Wire harness or connector
  3. Main body ECU (Network Gateway ECU)

WIRING DIAGRAM


E249072E01


INSPECTION PROCEDURE

1.INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY
  1. Perform inspection of the shift lock control unit assembly (Click here).



NG
REPLACE SHIFT LOCK CONTROL UNIT ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL UNIT ASSEMBLY)
  1. Disconnect the D5 main body ECU (network gateway ECU) connector.

  1. Disconnect the D28 shift lock control unit assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-20(SLS+) - D28-4(SLS+)
    Always
    Below 1 Ω
    D5-20(SLS+) or D28-4(SLS+) - Body ground
    Always
    10 kΩ or higher

  1. Connect the D5 main body ECU (network gateway ECU) connector.

  1. Connect the D28 shift lock control unit assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SHIFT LOCK CONTROL UNIT ASSEMBLY - BODY GROUND)
  1. Disconnect the D28 shift lock control unit assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D28-5(SLS-) - Body ground
    Always
    Below 1 Ω

  1. Connect the D28 shift lock control unit assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (SHIFT LOCK CONTROL UNIT ASSEMBLY - BODY GROUND)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)