AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Inspect the battery voltage.
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any code that is output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to force the A/C system to output DTCs by simulating the conditions indicated by the DTC.
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| |||||
| 5.DIAGNOSTIC TROUBLE CODE CHART |
Find the output DTCs in the diagnostic trouble code chart (Click here).
|
|
| 6.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Panel diagnosis (indicator check, sensor check) (Click here).
Data List / Active Test (Click here).
Terminals of ECU (Click here).
On-vehicle Inspection.
Inspection.
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|