Home › Engine / Hybrid System › FA20 LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil and oil filter element.



2. CHECK ENGINE OIL LEVEL
  1. Park the vehicle in a level place.

  1. With the engine turned off, check that the engine oil level is between the full level and low level marks.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not add engine oil above the full level mark.

    HINT:
    1. Check the oil level before the engine is started, or 5 minutes or more after the engine has been stopped (after engine warming).
    2. Check both sides of the dipstick and use the value obtained from the lower side oil level.



3. CHECK OIL PRESSURE
  1. Remove the oil pressure switch assembly (Click here).



    A276043
  1. Install the oil pressure gauge with adapter.

  1. Install the air cleaner assembly .

  1. Warm up the engine.

  1. Check the oil pressure under the following conditions.

    Specification Oil Pressure:
    Item
    Engine Oil Temperature
    Oil Pressure
    Idle
    80°C (176°F)
    50 kPa (0.5 kgf/cm2, 7.3 psi) or more
    6000 rpm
    500 kPa (5.1 kgf/cm2, 73 psi) or more

  1. Remove the air cleaner assembly .

  1. Remove the oil pressure gauge with adapter.

  1. Install the oil pressure switch assembly (Click here).

  1. Inspect for engine oil leaks.