Home › Drivetrain ยท AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION

DIFFERENTIAL MOUNT CUSHION > REMOVAL

for Preparation Click here



1. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
(Click here)


2. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    C262505
  1. Remove the 4 cushion rubbers and the tail exhaust pipe assembly.



3. REMOVE REAR STABILIZER BAR
(Click here)


4. REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    C260026E02
  1. Using SST, remove the rear No. 1 differential mount cushion.

    SST
    09570-18020   (09571-01100, 09571-01110, 09571-01140, 09571-01150, 09571-01160, 09571-01170, 09571-01180, 09571-01190)
    09922-10010  
    Text in Illustration 
    *1
    Rear Suspension Member
    *2
    Rear No. 1 Differential Mount Cushion
    *3
    SST(09571-01180)
    *4
    SST(09571-01160)
    *5
    SST(09571-01140)
    *6
    SST(09571-01170)
    *7
    SST(09571-01190)
    *8
    SST(09571-01110)
    *9
    SST(09571-01100)
    *10
    SST(09571-01150)
    *11
    SST(09922-10010)
    *a
    Hold
    *b
    Turn
    *c
    Start
    *d
    End
    V100135
    Front side

    NOTICE:
    1. Make sure that SST does not come into contact with the cylindrical part of the rear suspension member and is not set at an angle.
    2. Make sure that SST does not run on the weld bead around the cylindrical part.



5. REMOVE REAR NO. 2 DIFFERENTIAL MOUNT CUSHION


    C260030E01
  1. Using SST, remove the rear No. 2 differential mount cushion.

    SST
    09570-18010   (09571-01010, 09571-01020, 09571-01050, 09571-01060, 09571-01070, 09571-01080, 09571-01090)
    Text in Illustration 
    *1
    Rear Suspension Member
    *2
    Rear No. 2 Differential Mount Cushion
    *3
    SST(09571-01090)
    *4
    SST(09571-01070)
    *5
    SST(09571-01050)
    *6
    SST(09571-01080)
    *7
    SST(09571-01020)
    *8
    SST(09571-01010)
    *9
    SST(09571-01060)
    *a
    Hold
    *b
    Turn
    *c
    Start
    *d
    End
    V100135
    Front side