CAN COMMUNICATION SYSTEM > Steering Angle Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (STEERING ANGLE SENSOR (SPIRAL CABLE SUB-ASSEMBLY) BRANCH WIRE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the D56 steering angle sensor (spiral cable sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-3 (CANH) - D56-2 (CANL) | Cable disconnected from negative (-) battery terminal | 57 to 63 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor (Spiral Cable Sub-assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-1 (ESS) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor (Spiral Cable Sub-assembly)) |
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-4 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor (Spiral Cable Sub-assembly)) |
|
| ||||
| OK | ||
| ||