Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM


C305304E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - BATTERY AND BODY GROUND)
  1. Disconnect the H28 tire pressure warning ECU and receiver connector.



    C239106E10
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H28-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    H28-1 (IG) - Body ground
    Ignition switch off
    Below 1 V

Text in Illustration 
*a
Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H28-12 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)