This compares values calculated by the TCM with the data recorded after calculations when the ignition switch is turned to ON, and if these do not match, then the DTC is stored, and the power is cut to all solenoids (fixed to 4th).
DTC No.
DTC Detection Condition
Diagnosis Condition
Malfunction Status
Malfunction Time
Other
Trouble Area
P160A
Ignition switch is turned to ON
TCM internal malfunction. When the information recorded inside the TCM differs from that in the same trip while the ignition switch is ON.
-
1-trip detection logic
TCM
MONITOR DESCRIPTION
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.
INSPECTION PROCEDURE
NOTICE:
Perform the universal trip to clear permanent DTCs (Click here).
There is a possibility that the DTC P062F is issued from the ECUs of the TCM. Use GTS to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.