Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Pass the hood lock control cable assembly into the engine compartment.


    B312232E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Grommet
    *3
    Hood Cable Grommet
    *4
    Matchmark

  1. Engage 7 clamps shown in the illustration.



2. INSTALL HOOD LOCK ASSEMBLY
  1. Apply MP grease to the sliding areas of the hood lock assembly.



    B310946
  1. Connect the hood lock control cable assembly to the hood lock assembly.



    B310947E03
  1. Install the hood lock assembly with the 3 bolts in the order shown in the illustration.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }



3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

  1. Install the hood lock control lever sub-assembly with the bolt

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. INSPECT HOOD SUB-ASSEMBLY
(Click here)


5. ADJUST HOOD SUB-ASSEMBLY
(Click here)


6. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE



7. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side .



8. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .