Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > Headlight Beam Level Control Actuator Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU assembly actuates the headlight leveling motors according to vehicle conditions.

WIRING DIAGRAM


E220279E08


INSPECTION PROCEDURE

NOTICE:
Initialization is necessary when the headlight leveling ECU assembly is replaced (Click here).

1.CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the A16 headlight leveling ECU assembly connector.

  1. Disconnect the A62*1 or A40*2 headlight leveling motor connector.

    1. *1: for LH
    2. *2: for RH

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    for LH 
    Tester Connection
    Condition
    Specified Condition
    A16-18 (LH2) - A62-2 (LHB1)
    Always
    Below 1 Ω
    A16-11 (LH1) - A62-3 (LHM+)
    Always
    Below 1 Ω
    A16-24 (LH3) - A62-1 (LHE)
    Always
    Below 1 Ω
    for RH 
    Tester Connection
    Condition
    Specified Condition
    A16-17 (RH2) - A40-2 (RHB1)
    Always
    Below 1 Ω
    A16-10 (RH1) - A40-3 (RHM+)
    Always
    Below 1 Ω
    A16-23 (RH3) - A40-1 (RHE)
    Always
    Below 1 Ω


    Standard Resistance (Check for Short):
    for LH 
    Tester Connection
    Condition
    Specified Condition
    A16-18 (LH2) - Body ground
    Always
    10 kΩ or higher
    A16-11 (LH1) - Body ground
    Always
    10 kΩ or higher
    A16-24 (LH3) - Body ground
    Always
    10 kΩ or higher
    for RH 
    Tester Connection
    Condition
    Specified Condition
    A16-17 (RH2) - Body ground
    Always
    10 kΩ or higher
    A16-10 (RH1) - Body ground
    Always
    10 kΩ or higher
    A16-23 (RH3) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HEADLIGHT ASSEMBLY
  1. Replace the headlight assembly with a new or a known good one (Click here).

  1. Check the operation of the headlight leveling motors.

    OK:
    Headlight leveling motors operate normally.



NG
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)
OK

END (HEADLIGHT LEVELING MOTOR WAS DEFECTIVE)