POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| |||||
| 3.PRE-CHECK |
Measure the battery voltage.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the GTS to check if the LIN communication system is functioning normally (Click here).
| Result | Proceed to |
| No DTCs output | A |
| DTCs output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
| No DTCs output | A |
| DTCs output | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here).
Data List / Active Test (Click here).
Terminals of ECU (Click here).
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.RESET POWER WINDOW MOTOR |
If the power window regulator master switch assembly or power window regulator switch assembly LED is blinking, reset the power window regulator motor assembly (Click here).
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|