Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

The combination meter assembly blinks or turns off the seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly (for driver).

WIRING DIAGRAM


B314061E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (DRIVER SIDE SEAT BELT WARNING LIGHT)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Read the Data List according to the display on the GTS.

    OK:
    Driver side seat belt warning light condition can be switched by Active Test.


    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    ON/OFF
    -



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (FOR DRIVER)
  1. Remove the front seat inner belt assembly (Click here).

  1. Inspect the front seat inner belt assembly (Click here).



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY - COMBINATION METER ASSEMBLY - BODY GROUND)
  1. Disconnect the H19 front seat inner belt assembly connector. (for LHD)

  1. Disconnect the G3 front seat inner belt assembly connector. (for RHD)

  1. Disconnect the D7 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    H19-1 - D7-37 (DBKL)
    Always
    Below 1 Ω
    H19-1 - Body ground
    Always
    10 kΩ or higher
    H19-2 - Body ground
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    G3-1 - D7-37 (DBKL)
    Always
    Below 1 Ω
    G3-1 - Body ground
    Always
    10 kΩ or higher
    G3-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)