Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > High Beam Headlight Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) receives headlight dimmer switch information signals, and illuminates the high beam headlight.

WIRING DIAGRAM


E252211E01


INSPECTION PROCEDURE

HINT:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING GTS (HEAD LIGHT HI)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test

  1. Check that the relay operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Head Light Hi
    Headlight dimmer relay
    ON/OFF
    -

    OK:
    Relay operates (high beam headlights illuminate).

    Result:
    Result
    Proceed to
    NG
    A
    OK
    B



B
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
A


2.INSPECT DIM RELAY
  1. Remove the DIM relay from the engine room relay block.

  1. Inspect the DIM relay (Click here).



NG
REPLACE DIM RELAY
OK


3.CHECK HARNESS AND CONNECTOR (BATTERY - DIM RELAY)
E252213E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Relay terminal 5 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Engine Room Relay Block
    (DIM Relay Terminal)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (DIM RELAY - MAIN BODY ECU (NETWORK GATEWAY ECU))
  1. Disconnect the A73 main body ECU (network gateway ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection
Condition
Specified Condition
Relay terminal 2 - A73-11 (DIM)
Always
Below 1 Ω
Relay terminal 1 - A73-23
Always
Below 1 Ω

Standard Resistance (Check for Short):
Tester Connection
Condition
Specified Condition
A73-11 (DIM) - Body ground
Always
10 kΩ or higher
A73-23 - Body ground
Always
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)