Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL SWITCH (for LHD)

CLUTCH PEDAL SWITCH (for LHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH START SWITCH ASSEMBLY
  1. Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the clutch start switch connector.



    C263918E01
  1. With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.
    Text in Illustration 
    *a
    Clearance

    Standard clearance:
    3.5 to 4.0 mm (0.138 to 0.157n.)

    HINT:
    Do not turn the clutch start switch assembly.



2. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
(Click here)


3. INSTALL CLUTCH SWITCH ASSEMBLY
  1. Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the clutch switch connector.



    C262743E01
  1. Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.
    Text in Illustration 
    *a
    No Clearance

    HINT:
    Do not turn the clutch switch assembly.



4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



6. INSTALL INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure as for the RH side.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



8. INSPECT CLUTCH START SYSTEM
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace or adjust the clutch start switch assembly.