Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for LHD)

BRAKE BOOSTER (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure for the LH side as for the RH side .



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE LOWER NO. 1 INSTRUMENT FANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


4. REMOVE TCM (for Automatic Transmission)
(Click here)


5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


6. DISCONNECT VACUUM TUBE CONNECTOR HOSE
  1. Slide the clip and disconnect the vacuum tube connector hose from the brake booster assembly.



7. REMOVE FRONT NO. 1 BRAKE TUBE


    C263593
  1. Using a union nut wrench 12 mm, disconnect the front No. 1 brake tube from the brake actuator.



    C263595E01
  1. Disconnect 2 clips and remove the front No. 1 brake tube.



8. REMOVE FRONT NO. 2 BRAKE TUBE


    C263594
  1. Using a union nut wrench 12 mm, disconnect the front No. 2 brake tube from the brake actuator.



    C263596E01
  1. Disconnect 2 clips and remove the front No. 2 brake tube.



9. REMOVE BRAKE BOOSTER ASSEMBLY
  1. Loosen the push rod clevis lock nut.



    C263601
  1. Remove the 4 nuts.



    C263602
  1. Remove the push rod clevis pin.

  1. Remove the brake booster assembly.



10. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Remove the brake master cylinder push rod clevis and lock nut.