DTC B2312 Driver Side Master Switch ON Stuck |
DTC B2315 Passenger Side P/W Switch ON Stuck |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2312 |
| Power window regulator master switch assembly |
| B2315 |
|
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check the DTCs (Click here).
| Result | Proceed to |
| DTC B2312 is output | A |
| DTC B2315 is output | B |
|
| ||||
| A | ||
| ||
| 2.READ VALUE USING GTS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Master Switch / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Door P/W Auto SW | Front passenger side power window auto switch signal / ON or OFF | ON: Front passenger side power window auto up/down switch operated OFF: Front passenger side power window switch not operated | - |
| P Door P/W Up SW | Front passenger side power window manual up signal / ON or OFF | ON: Front passenger side power window manual up switch operated OFF: Front passenger side power window switch not operated | - |
| P Door P/W Down SW | Front passenger side power window manual down signal / ON or OFF | ON: Front passenger side power window manual down switch operated OFF: Front passenger side power window switch not operated | - |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - POWER WINDOW MOTOR) |
Disconnect the E8*1 or F6*2 power window regulator master switch assembly connector.
Disconnect the F6*1 or E8*2 power window regulator switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-2 (UART) - F6-2 (UART) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E8-2 (UART)*1 - Body ground | Always | 10 kΩ or higher |
| F6-2 (UART)*2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||