Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

DTC    U0140    Lost Communication with Body Control Module

DTC    U0155    Lost Communication with Instrument Panel Cluster Control Module (Combination Meter)

for Preparation Click here


DESCRIPTION

The TCM receives and transmits signals from each ECU using CAN communication.

HINT:
  1. Problems on the CAN bus (communication line) can be detected from the DLC3 connector (Except when the DLC3 branch line is open).
  2. By using the GTS, it is possible to check CAN communication DTC.
  3. The DLC3 is connected to the CAN communication line, but the CAN communication is unable to detect problems on the DLC3 branch line.


DTC No.
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
U0100
  1. CAN bus is normal.
  2. Signal from the ECM is interrupted.
  3. 500 ms, 800 ms, 2000 ms (differs depending on ID)
  4. 1-trip detection logic
CAN communication system
U0122
  1. CAN bus is normal.
  2. Signal from the skid control ECU (brake actuator assembly) is interrupted.
  3. 800 ms
  4. 1-trip detection logic
CAN communication system
U0140
  1. CAN bus is normal.
  2. Signal from the main body ECU (network gateway ECU) is interrupted.
  3. 800 ms, 20000 ms (differs depending on ID)
  4. 1-trip detection logic
CAN communication system
U0155
  1. CAN bus is normal.
  2. Signal from combination meter assembly is interrupted.
  3. 2000 ms
  4. 1-trip detection logic
CAN communication system

INSPECTION PROCEDURE

NOTICE:
Perform the universal trip to clear permanent DTCs (Click here).

1.CHECK OTHER DTC OUTPUT
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and push the GTS main switch ON.

  1. Read the DTCs using the GTS (Click here).


Result:

Display (DTC output)
Proceed to
U0100, U0122, U0140 or U0155
A
U0100, U0122, U0140 or U0155 and P160A
B



B
GO TO P160A (Click here)
A


2.CHECK DTC OUTPUT
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and push the GTS main switch ON.

  1. Read the DTCs using the GTS (Click here).


NEXT

GO TO CAN COMMUNICATION SYSTEM (Click here)