Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the steering lock system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

        HINT:
        A simple method to determine whether the battery is depleted is to operate the horn.


      NEXT


      4.CHECK DTC*
      1. Check for DTCs and make a note of any codes that are output (Click here).
        Result 
        Result
        Proceed to
        No DTCs output
        Problem symptom can be confirmed and reproduced
        A
        Problem symptom cannot be confirmed or reproduced
        B
        Steering lock system DTCs output
        C
        LIN communication DTCs output
        D

        HINT:
        1. When steering lock system DTCs are output, refer to Diagnostic Trouble Code Chart (Click here).
        2. The steering lock system does not store past DTCs.



      B.
      USE SIMULATION METHOD TO CHECK (Click here)

      C.
      Go to step 7

      D.
      GO TO LIN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault not listed in problem symptoms table
        A
        Fault listed in problem symptoms table
        B



      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).


      NEXT


      7.REPAIR OR REPLACE

        NEXT


        8.CHECK DTC AGAIN*
        1. Clear the DTCs (Click here).

        2. Check for DTCs and make a note of any codes that are output (Click here).

          HINT:
          Perform the DTC output confirmation operation.

          Result 
          Result
          Proceed to
          No DTCs output
          A
          DTCs output
          B



        B.
        GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
        A

        END