Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B1411    Immobiliser Antenna Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) stores this code if a malfunction is detected in the antenna coil inside the transponder key amplifier.

DTC Code
DTC Detection Condition
Trouble Area
B1410
Malfunction in the antenna coil inside the transponder key amplifier.
  1. Transponder key amplifier
  2. Main body ECU (network gateway ECU)

INSPECTION PROCEDURE

NOTICE:
If the main body ECU (network gateway ECU) is replaced, refer to Service Bulletin.

1.CHECK FOR DTC
  1. Key is removed from ignition key cylinder.

  1. Key is inserted into ignition key cylinder.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

OK:
DTC B1411 is not output.



NG
Go to step 2
OK

END 

2.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or known good one (Click here).


NEXT


3.CHECK FOR DTC
  1. Key is inserted into ignition key cylinder.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

OK:
DTC B1411 is not output.



NG
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
OK

END