Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B1402    Immobiliser Key Check NG

for Preparation Click here


DESCRIPTION

The main body ECU (network gateway ECU) stores this code if an improper key (a key not registered in the main body ECU (network gateway ECU)) is inserted into the ignition key cylinder.

DTC Code
DTC Detection Condition
Trouble Area
B1402
When an improper key (a key not registered in the main body ECU (network gateway ECU)) is inserted into the ignition key cylinder.
  1. Key
  2. Main body ECU (network gateway ECU)

INSPECTION PROCEDURE

NOTICE:
If the main body ECU (network gateway ECU) is replaced, refer to Service Bulletin.

1.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B1410 and B1411 is not output.



NG
GO TO DTC CHART (Click here)
OK


2.REGISTER KEY
  1. Reregister the key (Refer to Service Bulletin).

OK:
The key ID can be registered.



NG
Go to step 3
OK

END 

3.REGISTER KEY
  1. Using an unregistered key, register the key ID (Refer to Service Bulletin).

OK:
The key ID can be registered.



NG
REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)
OK

END