Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Speedometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the speedometer in accordance with the vehicle speed signals from the skid control ECU (brake actuator assembly) through the CAN communication system.

WIRING DIAGRAM


E220689E07


INSPECTION PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
  1. Check if meter / gauge system DTCs are output (Click here).

    OK:
    DTCs are not output.



NG
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
OK


2.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check if the vehicle stability control system outputs DTCs (Click here).

    OK:
    DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


3.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120, 160, 200, 240 km/h
    -

    OK:
    The vehicle speed displayed on the tester is approximately the same as that of the speedometer reading.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) (Click here)