Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for RHD)

BRAKE BOOSTER (for RHD) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.



1. REMOVE INSTRUMENT SIDE PANEL RH (w/o Knee Airbag)

HINT:
Use the same procedure for the LH side as for the RH side .



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE LOWER NO.1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)
(Click here)


4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


5. REMOVE TCM (for Automatic Transmission)
(Click here)


6. REMOVE PUSH ROD PIN


    C259963
  1. Remove the clip and the push rod pin from the push rod clevis.



7. REMOVE BRAKE BOOSTER ASSEMBLY


  1. Disengage each clamp as shown in the illustration.


    C259981

  1. Displace the clamp and disconnect the brake booster assembly vacuum hose.



    C256674
  1. Remove the 4 nuts and brake booster assembly from the vehicle body.

    NOTICE:
    Do not kink or damage the brake lines.



8. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Remove the brake master cylinder push rod clevis and lock nut.