Home › Brake › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE SWITCH ASSEMBLY
  1. Install the parking brake switch assembly with the screw.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



2. INSTALL PARKING BRAKE LEVER ASSEMBLY
  1. Install the parking brake lever assembly with the 3 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the parking brake switch assembly connector.



3. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Temporarily install the NO. 1 parking brake cable assembly to the parking brake lever with the adjusting nut.

  1. Install the NO. 2 parking brake cable assembly and NO. 3 to the NO. 1 parking brake cable assembly.



4. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Fully pull the parking brake lever to engage the parking brake.

  1. Pull the lever again to disengage the parking brake.

  1. Slowly pull the parking brake lever using the specified force, and count the number of clicks.

    Parking brake lever travel:
    7 to 8 notches at 200 N (20 kgf, 45.0 lbf)

    If the parking brake lever travel is not as specified, adjust the parking brake shoe clearance and parking brake lever travel.



5. ADJUST PARKING BRAKE LEVER TRAVEL
  1. Remove the front console box (Click here).

  1. Completely release the parking brake lever.



    C263604E01
  1. Loosen the adjusting nut to completely release the parking brake cable.
    Text in Illustration 
    *1
    Adjusting nut

  1. Remove the rear wheels.

  1. Temporarily install the hub nuts to the hub bolts.

  1. Remove the parking brake shoe adjusting hole plug.



  1. Turn the shoe adjuster and expand the shoes until the disc locks.


    C262318E01


    Text in illustration 
    *a
    Expand
    *b
    Contract

  1. Turn and contract the shoe adjuster until the disc can rotate smoothly.

    Standard:
    Returns 10 notches.

  1. Check that there is no brake drag against the shoe.

  1. Install the parking brake shoe adjusting hole plug.

  1. Turn the adjusting nut until the parking brake lever travel is corrected to be within the specified range.

    Parking brake lever travel:
    7 to 8 notches at 200 N (20 kgf, 45.0 lbf)

  1. Using a wrench or an equivalent tool, tighten the adjusting nut.

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

    Parking brake lever travel:
    7 to 8 notches at 200 N (20 kgf, 45.0 lbf)

  1. Check that the parking brake does not drag.

  1. Remove the hub nuts from the hub bolts.

  1. Install the rear wheels.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

  1. Install the front console box (Click here).



6. INSTALL CONSOLE BOX ASSEMBLY
(Click here)