Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1515    Torque Sensor Zero Point Adjustment Undone

DTC    C1525    Rotation Angle Sensor Initialization Undone

for Preparation Click here


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration have not been performed.

DTC Code
DTC Detection Condition
Trouble Area
C1515
Torque sensor zero point calibration has not been performed.
There is no malfunction if this DTC is not output again after performing torque sensor zero point calibration.
C1525
Rotation angle sensor value initialization has not been performed.
There is no malfunction if this DTC is not output again after performing rotation angle sensor value initialization.

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    NOTICE:
    If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.


    Result 
    Condition
    Proceed to
    DTC C1515 or C1525 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times.
    A
    DTC C1515 or C1525 is not output.
    B



B
END
A


3.REPLACE POWER STEERING ECU ASSEMBLY
  1. Replace the power steering ECU assembly (Click here).


NEXT


4.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTCs (Click here).

    NOTICE:
    If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.


    Result 
    Condition
    Proceed to
    DTC C1515 or C1525 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times.
    A
    DTC C1515 or C1525 is not output.
    B



B
END
A

REPLACE STEERING COLUMN ASSEMBLY (Click here)