Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1516    Torque Sensor Zero Point Adjustment Incomplete

DTC    C1526    Rotation Angle Sensor Initialization Incomplete

for Preparation Click here


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration are incomplete.

DTC Code
DTC Detection Condition
Trouble Area
C1516
Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration.
There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration.
C1526
Rotation angle sensor value initialization is incomplete due to the steering wheel being touched during calibration.
There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing rotation angle sensor value initialization.

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CLEAR DTC
  1. Clear the DTC(s) (Click here).


NEXT


2.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).


NEXT


3.CHECK FOR DTC
  1. Check for DTCs (Click here).

    NOTICE:
    If DTC C1516 or C1526 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform the calibration and initialization 3 times.


    Result 
    Condition
    Proceed to
    DTC C1516 or C1526 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times.
    A
    DTC C1516 or C1526 is not output.
    B



B
END
A


4.REPLACE POWER STEERING ECU ASSEMBLY
  1. Replace the power steering ECU assembly (Click here).


NEXT


5.CLEAR DTC
  1. Clear the DTC(s) (Click here).


NEXT


6.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
  1. Initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTCs (Click here).

    NOTICE:
    If DTC C1516 or C1526 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.


    Result 
    Condition
    Proceed to
    DTC C1516 or C1526 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times.
    A
    DTC C1516 or C1526 is not output.
    B



B
END
A

REPLACE STEERING COLUMN ASSEMBLY (Click here)