Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the RHD vehicle.



1. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B359228
  1. Engage the 4 claws to install the power window regulator master switch assembly.



2. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    B314154
  1. Install the power window regulator master switch assembly with front door armrest base panel with the 4 screws.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B313122E01
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly to the front door inside handle.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable Assembly
    *2
    Front Door Lock Remote Control Cable Assembly

  1. Connect each connector.



    B314824
  1. Engage the 10 clips and install the front door trim board sub-assembly.



    B313120
  1. Engage the clip and install the 3 screws.



    B314825
  1. Engage the claw and install the cap.



4. INSTALL DOOR ARMREST COVER LH


    B314960
  1. Engage the guide and 7 claws, and install the door armrest cover.



5. INITIALIZE POWER WINDOW CONTROL SYSTEM
(Click here)


6. INSPECT POWER WINDOW OPERATION
(Click here)