Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Engine Switch Illumination Circuit

for Preparation Click here


DESCRIPTION

The illuminated entry system controls the engine switch illumination.

WIRING DIAGRAM


E212454E10


INSPECTION PROCEDURE

NOTICE:
  1. Before performing the following inspection, check that the engine switch illumination has not been turned off using the rheostat function.
  2. The engine switch illumination can be turned off by using the rheostat knob to select the minimum illuminance level with the taillights on.

1.PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check that the illumination operates.

    OK:
    Engine switch illumination comes on.


    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Engine switch illumination
    ON/OFF
    -



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT ENGINE SWITCH
  1. Remove the engine switch (Click here).

  1. Inspect the engine switch (Click here).

OK:
Engine switch illumination comes on.



NG
REPLACE ENGINE SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
  1. Disconnect the D41 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the D25 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-16 (SWIL) - D25-9 (SWIL)
    Always
    Below 1 Ω
    D41-24 (AGND) - D25-6 (AGND)
    Always
    Below 1 Ω
    D41-16 (SWIL) - Body ground
    Always
    10 kΩ or higher
    D41-24 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)