ENTRY AND START SYSTEM (for Entry Function) > Front Passenger Side Door Entry Unlock Function does not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the power window regulator master switch assembly is operated, check that the doors unlock and lock according to switch operation (Click here).
|
| ||||
| OK | |
| 2.READ VALUE USING GTS (P-DOOR LOCK POS SW) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P-Door Lock Pos SW | Passenger side door unlock detection switch signal / LOCK or UNLOCK | LOCK: Passenger side door locked UNLOCK: Passenger side door unlocked | - |
|
| ||||
| OK | |
| 3.READ VALUE USING GTS (P-DOOR TOUCH SENSOR) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Entry & Start / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P-Door Touch Sensor | Front door outside handle assembly (for front passenger side) (unlock sensor) / OFF or ON | OFF: Front door outside handle assembly (for front passenger side) (unlock sensor) not touched ON: Front door outside handle assembly (for front passenger side) (unlock sensor) touched |
|
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - FRONT DOOR OUTSIDE HANDLE ASSEMBLY) |
Disconnect the D41 and D48 certification ECU (smart key ECU assembly) connectors.
Disconnect the F5*1 or E1*2 front door outside handle assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D41-23 (SEN2) - F5-4 (SENS) | Always | Below 1 Ω |
| D48-11 (GND) - Body ground | Always | Below 1 Ω |
| D41-23 (SEN2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| D41-23 (SEN2) - E1-4 (SENS) | Always | Below 1 Ω |
| D48-11 (GND) - Body ground | Always | Below 1 Ω |
| D41-23 (SEN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY (FOR PASSENGER SIDE DOOR) |
Reconnect the D41 and D48 certification ECU (smart key ECU assembly) connectors.
Reconnect the E1*1 or F5*2 front door outside handle assembly (for passenger side door) connector.
Using an oscilloscope, check the waveform.

| *a | Component with harness connected (Certification ECU (smart key ECU assembly)) | *b | Waveform |
| *c | In actuality, sampling is being performed | - | - |
| Tester Connection | Condition | Tool Setting | Specified Condition |
| D41-23 (SEN2) - D48-11 (GND) | Procedure:
| 2 V/DIV., 500 ms/DIV | Pulse generation (See waveform) |
|
| ||||
| OK | ||
| ||