REAR FLOOR AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL NO. 2 AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Connect the connector to the No. 2 airbag sensor assembly.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
Insert the pin (stopper) into the rear floor hole and install the No. 2 airbag sensor assembly to the rear floor panel with the nut.
Check that there is no looseness in the installation parts of the rear floor airbag sensor.
| 2. INSTALL CONSOLE BOX ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 5. CHECK SRS WARNING LIGHT |