CANISTER > REMOVAL |
| 1. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY |
| 2. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY |
| 3. REMOVE CANISTER PUMP MODULE (for Metal Type) |
![]() |
Disconnect the drain hose B as indicated by the arrows, in the order shown in the illustration.
![]() |
Disconnect the drain hose A as indicated by the arrows, in the order shown in the illustration.
![]() |
Disconnect the evaporation hose from the fuel filler pipe assembly.
Disengage the clip.
![]() |
Remove the 3 bolts and check valve.
Disengage the clip.
![]() |
Disengage the clamp.
Remove the nut and bracket B.
![]() |
Remove the 2 nuts and bracket A.
![]() |
Disconnect the drain hose A and drain hose B as indicated by the arrows, in the order shown in the illustration.
| *1 | Drain hose A |
| *2 | Drain hose B |
![]() |
Disconnect the 2 quick connector as indicated by the arrows, in the order shown in the illustration, and remove the drain hose E.
| 4. REMOVE CHARCOAL CANISTER ASSEMBLY (for Metal Type) |
![]() |
Disconnect the drain hose D as indicated by the arrows, in the order shown in the illustration.
![]() |
Disconnect the drain hose C as indicated by the arrows, in the order shown in the illustration.
![]() |
Remove the nut.
![]() |
Remove the 2 bolts and charcoal canister assembly along with the canister base bracket B.
![]() |
Remove the 2 nuts and canister base bracket.
| 5. REMOVE FUEL OUTLET VALVE ASSEMBLY (for Clamp Type) |
![]() |
Disconnect the evaporation hose from the fuel outlet valve assembly.
| *1 | Evaporation hose |
| *2 | Drain hose |
Disengage the hose clamp, and disconnect the evaporation hose and drain hose.
![]() |
Disengage the clamp, and remove the fuel outlet valve assembly.
| 6. REMOVE CHARCOAL CANISTER ASSEMBLY (for Clamp Type) |
![]() |
Disengage the 3 hose clamps, and disconnect the drain hose and drain tube.
| *1 | Drain hose |
| *2 | Drain tube |
![]() |
Disconnect the purge tube.
![]() |
Remove the 2 bolts and nut, and remove the charcoal canister assembly with canister bracket A and canister bracket B.
![]() |
Remove the 3 nuts, canister bracket A, and canister bracket B.
| *1 | Canister bracket A |
| *2 | Canister bracket B |