Home › Suspension › REAR SUSPENSION › TOE CONTROL LINK

TOE CONTROL LINK > INSTALLATION

for Preparation Click here


HINT:
  1. The procedure listed below is for the LH side.
  2. Use the same procedure for the RH and LH sides.



1. TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH
  1. Install the toe control link sub-assembly LH and insert the toe adjust cam from the front of the vehicle. Then, install the rear No. 2 suspension toe adjust plate and temporarily install the new nut.

    NOTICE:
    Align the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate.

  1. Install the rear suspension toe control link sub-assembly LH to the rear axle carrier side with a nut.

    Torque:
    60 N*m{ 612 kgf*cm , 44 ft.*lbf }

  1. Install the new snap pin.



2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
  1. Temporarily install the rear No. 1 suspension arm assembly LH to the axle carrier with the new bolt and new nut.

    NOTICE:
    Insert the bolt from inside the vehicle.

  1. Temporarily install the rear No. 1 suspension arm assembly LH to the rear suspension member with the new bolt and new nut.

    NOTICE:
    Insert the bolt from outside the vehicle.



3. STABILIZE SUSPENSION


    C261010E01
  1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the suspension so that the rear drive shaft assembly becomes level.
    Text in Illustration 
    *a
    Wooden Block



4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH
  1. Fully tighten the nut on the rear suspension member side.

    Torque:
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf }

    NOTICE:
    Check that the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate are aligned.



5. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
  1. Fully tighten the 2 bolt and 2 nut of the rear No. 1 suspension arm assembly LH.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }



6. INSTALL REAR WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)


8. VSC SENSOR NEUTRAL MEMORIZATION
(Click here)