Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU

HEADLIGHT LEVELING ECU > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicle.



1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY
  1. Install the headlight leveling ECU assembly with the nut.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL POWER STEERING ECU ASSEMBLY


    C260461E01
  1. Disengage the clamp.

  1. Disconnect the connector from the power steering ECU assembly.

    1. As shown in the illustration, pull out the lock of the lock lever and turn the lock lever to disconnect the connector.
      Text in Illustration 
      *a
      Pull out the lock
      *b
      Turn the lock lever

  1. Disconnect the 3 connectors from the power steering ECU assembly.



    C260462
  1. Disengage the clamp.

  1. Remove the 2 bolts and power steering ECU assembly.



3. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(Click here)


4. HEADLIGHT LEVELING ECU INITIALIZATION
(Click here)