LIGHTING SYSTEM > Ignition Key Cylinder Light Circuit |

| 1.PERFORM ACTIVE TEST USING GTS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the light operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Key Ring Light | Ignition key cylinder light | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT TRANSPONDER KEY AMPLIFIER |
Remove the transponder key amplifier (Click here).
Inspect the transponder key amplifier (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY AMPLIFIER - BATTERY) |
Disconnect the D54 transponder key amplifier connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D54-2 (ILL+) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to transponder key amplifier) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY AMPLIFIER - MAIN BODY ECU (NETWORK GATEWAY ECU)) |
Disconnect the D54 transponder key amplifier connector.
Disconnect the D5 main body ECU (network gateway ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D54-6 (ILL-) - D5-28 (ILL) | Always | Below 1 Ω |
| D5-28 (ILL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||