POWER WINDOW CONTROL SYSTEM > Driver Side Index Function does not Operate |
| 1.READ VALUE USING GTS (D Door Courtesy SW) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door opened OFF: Driver side door closed | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION |
Initialize the power window regulator master switch assembly (Click here).
Check the power window regulator master switch assembly is operated (Click here).
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | |
| 3.READ VALUE USING GTS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Current D Door Glass Position Information | Glass position of the driver side power window / -100 to 700 | - | - |
|
| ||||
| OK | |
| 4.CHECK POWER WINDOW REGULATOR ASSEMBLY |
Check the power window regulator master switch assembly operates (Click here).
| Result | Proceed to |
| Operate (Does not window glass operate) | A |
| Does not operate | B |
|
| ||||
| A | |
| 5.REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY |
Temporarily replace the power window regulator motor assembly with a new or normally functioning one (Click here).
Check the power window regulator master switch assembly operates (Click here).
| Result | Proceed to |
| Operate | A |
| Does not operate | B |
|
| ||||
| A | ||
| ||
| 6.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Click here).
Check the power window regulator master switch assembly operates (Click here).
| Result | Proceed to |
| Does not operate | A |
| Operate | B |
|
| ||||
| A | |
| 7.REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY |
Temporarily replace the power window regulator motor assembly with a new or normally functioning one (Click here).
Check the power window regulator master switch assembly operates (Click here).
| Result | Proceed to |
| Operate | A |
| Does not operate | B |
|
| ||||
| A | ||
| ||