Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › SFI SYSTEM
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297470 SFI SYSTEM D

FA20 ENGINE CONTROL  SFI SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the GTS when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

2.

Switch the ECM from normal mode to check mode using the GTS (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>CHECK MODE PROCEDURE).

3.

Perform a simulation test.

4.

Check and wiggle the harness(es), connector(s) and terminal(s).